The Highlander
New Member
- Joined
- Mar 16, 2007
- Messages
- 8,235
- Reaction score
- 1
Wow, cheapest price... They are reman. Bosch fuel injectors, and 12 months warranty.
If you are about to replace any of the fuel injectors, you must identify a six-digit alphanumeric correction code that printed on the intake side of the fuel injector, you have to use a scan tool to calibrate the correction codes (enter correction codes into the vehicle's ECM. Don't mix fuel injectors when you removed from the cylinder head, place them in order. Best way to ID fuel injectors in the cylinder head prior to injector removal. Not recommend for DIYers without factory scan tool. I never been run across on these before. I'm glad that some diesel vehicles didn't show up my work.
That's correct, OEM scan tool is damn expensive for J1939 plug. For CAT? You have give VIN to CAT dealer then they will give you the correction codes with fuel injector correct. I don't understand why Diesel made too complex for electric fuel injector than gasoline.
Sad, I see a lot semi-trucks have problem with DPF (diesel particulate filter) and DEF (Diesel Exhaust Fluid) system. Two days ago, Peterbilt got engine light code and and it had 5 codes as DEF got low voltage/out of range,heater out of ranger, pressures out of range,cant remember what other code . So I inspected whole harness and it looks fine then I unplugged the connector plugs from the DEF's PUMP and DEF leaking almost over my face. Ugh. I never thought of that. So I checked harness connector plug and it had corrosion so I cleaned it with QD electronic cleaner and wire brush then checked with DMM and it was around 2-3 volts should be 12v. So I replaced the harness and DEF pump. DEF PUMP cost around $400 and harness cost around $100.
For IH (International )? It's FAMOUS issue with oil leaking/coolant leaking, EGR cooler junk, etc.